Free shark SVG

Shark tail above the water SVG

Which one? SVG for Cricut and lasers, DXF for the free Silhouette Studio, PNG to print.

Free for personal and commercial use, no sign-up. What you can do with it.

Shark tail above the water, as a solid black shape
Shark tail above the water. The preview is the SVG file itself.

The tail of a diving shark standing out of a strip of sea: a long upper lobe, a shorter lower one and a slim stalk. A companion piece to the fin.

What is in the file

Size100 × 91 mm (3.94 × 3.57 in), scales to any size
PiecesOne piece: it holds together when cut
Outlines to cut3: 1 outer edge and 2 cut-outs
Cut length600 mm at this size
Narrowest part1.2 mm at this size
Nodes122 curve and line segments

Measured from the file. PNG: 2,000 × 1,821 pixels, transparent. About the three file types.

Will it cut at your size?

Scaling a design scales its thinnest part too. Here is this one at seven sizes, from 1 to 12 inches on its longer side, with how many copies fit a 12 × 12 inch sheet or mat.

Size, width × heightNarrowest partCut lengthFit on a 12 in sheetRule of thumb
1 × 0.91 in (25 × 23 mm)0.3 mm152 mm110Too fine for most machines
2 × 1.81 in (51 × 46 mm)0.61 mm305 mm30Fine detail: vinyl and paper only, weed with care
3 × 2.72 in (76 × 69 mm)0.91 mm457 mm12Fine detail: vinyl and paper only, weed with care
4 × 3.63 in (102 × 92 mm)1.2 mm610 mm6Vinyl, card and thin sheet
6 × 5.44 in (152 × 138 mm)1.8 mm914 mm2Vinyl, card and thin sheet
8 × 7.26 in (203 × 184 mm)2.4 mm1,219 mm1Vinyl, card and thin sheet
12 × 10.88 in (305 × 276 mm)3.7 mm1,829 mm1Any material, including 3 mm wood and acrylic

The narrowest part is the thinnest neck or wall beside a cut-out; sharp tips are not counted. For wood and acrylic, keep it at least as wide as the sheet is thick. How to open the file in Cricut, Silhouette and laser software.

More shark SVG files

← Shark fin in the water All 16 sharks Shark tooth →