Surfboard with a shark bite SVG
A surfboard with a ragged bite taken out of one edge, a centre line and two tail stripes. A joke for surf shop signs, beach house doors and lucky escapes.
Free for personal and commercial use, no sign-up. What you can do with it.
What is in the file
| Size | 47 × 100 mm (1.85 × 3.94 in), scales to any size |
|---|---|
| Pieces | One piece: it holds together when cut |
| Outlines to cut | 4: 1 outer edge and 3 cut-outs |
| Cut length | 469 mm at this size |
| Narrowest part | 2.5 mm at this size |
| Nodes | 92 curve and line segments |
Measured from the file. PNG: 983 × 2,000 pixels, transparent. About the three file types.
Will it cut at your size?
Scaling a design scales its thinnest part too. Here is this one at seven sizes, from 1 to 12 inches on its longer side, with how many copies fit a 12 × 12 inch sheet or mat.
| Size, width × height | Narrowest part | Cut length | Fit on a 12 in sheet | Rule of thumb |
|---|---|---|---|---|
| 0.47 × 1 in (12 × 25 mm) | 0.64 mm | 119 mm | 180 | Fine detail: vinyl and paper only, weed with care |
| 0.94 × 2 in (24 × 51 mm) | 1.3 mm | 238 mm | 50 | Vinyl, card and thin sheet |
| 1.41 × 3 in (36 × 76 mm) | 1.9 mm | 357 mm | 21 | Vinyl, card and thin sheet |
| 1.88 × 4 in (48 × 102 mm) | 2.5 mm | 477 mm | 10 | Vinyl, card and thin sheet |
| 2.83 × 6 in (72 × 152 mm) | 3.8 mm | 715 mm | 4 | Any material, including 3 mm wood and acrylic |
| 3.77 × 8 in (96 × 203 mm) | 5.1 mm | 953 mm | 3 | Any material, including 3 mm wood and acrylic |
| 5.65 × 12 in (144 × 305 mm) | 7.6 mm | 1,430 mm | 2 | Any material, including 3 mm wood and acrylic |
The narrowest part is the thinnest neck that holds the design together; sharp tips are not counted. For wood and acrylic, keep it at least as wide as the sheet is thick. How to open the file in Cricut, Silhouette and laser software.
Three circling sharks 
Great white shark 
Shark silhouette 
Shark outline 
Cute cartoon shark 
Leaping shark 
Hammerhead shark from above 
Whale shark with spots 