Leaping bunny SVG
Which one? SVG for Cricut and lasers, DXF for the free Silhouette Studio, PNG to print.
Free for personal and commercial use, no sign-up. What you can do with it.
A hare at full stretch: front legs reaching, back legs kicked out behind and ears laid back. Long and low, for borders, banners and the side of a mug.
This shape is also a part in the shadow box scene maker, where you can stand it in a layered scene and download the sheets.
What is in the file
| Size | 100 × 66 mm (3.94 × 2.61 in), scales to any size |
|---|---|
| Pieces | One piece: it holds together when cut |
| Outlines to cut | 2: 1 outer edge and 1 cut-out |
| Cut length | 364 mm at this size |
| Narrowest part | 5.7 mm at this size |
| Nodes | 103 curve and line segments |
| Also found as | Jumping bunny SVG |
Measured from the file. PNG: 2,000 × 1,350 pixels, transparent. About the three file types.
Will it cut at your size?
Scaling a design scales its thinnest part too. Here is this one at seven sizes, from 1 to 12 inches on its longer side, with how many copies fit a 12 × 12 inch sheet or mat.
| Size, width × height | Narrowest part | Cut length | Fit on a 12 in sheet | Rule of thumb |
|---|---|---|---|---|
| 1 × 0.66 in (25 × 17 mm) | 1.4 mm | 92 mm | 140 | Vinyl, card and thin sheet |
| 2 × 1.32 in (51 × 34 mm) | 2.9 mm | 185 mm | 40 | Vinyl, card and thin sheet |
| 3 × 1.99 in (76 × 50 mm) | 4.3 mm | 277 mm | 15 | Any material, including 3 mm wood and acrylic |
| 4 × 2.65 in (102 × 67 mm) | 5.8 mm | 370 mm | 8 | Any material, including 3 mm wood and acrylic |
| 6 × 3.97 in (152 × 101 mm) | 8.7 mm | 555 mm | 2 | Any material, including 3 mm wood and acrylic |
| 8 × 5.3 in (203 × 135 mm) | 12 mm | 740 mm | 2 | Any material, including 3 mm wood and acrylic |
| 12 × 7.94 in (305 × 202 mm) | 17 mm | 1,109 mm | 1 | Any material, including 3 mm wood and acrylic |
The narrowest part is the thinnest neck or wall beside a cut-out; sharp tips are not counted. For wood and acrylic, keep it at least as wide as the sheet is thick. How to open the file in Cricut, Silhouette and laser software.