Pig snout SVG
Which one? SVG for Cricut and lasers, DXF for the free Silhouette Studio, PNG to print.
Free for personal and commercial use, no sign-up. What you can do with it.
A snout on its own: an oval with two nostrils and a small hole at each side for elastic. Cut it from pink card or foam at 70 mm wide for a mask.
What is in the file
| Size | 100 × 74 mm (3.94 × 2.91 in), scales to any size |
|---|---|
| Pieces | One piece: it holds together when cut |
| Outlines to cut | 5: 1 outer edge and 4 cut-outs |
| Cut length | 454 mm at this size |
| Narrowest part | 4.2 mm at this size |
| Nodes | 37 curve and line segments |
| Symmetry | Mirror |
Measured from the file. PNG: 2,000 × 1,498 pixels, transparent. About the three file types.
Will it cut at your size?
Scaling a design scales its thinnest part too. Here is this one at seven sizes, from 1 to 12 inches on its longer side, with how many copies fit a 12 × 12 inch sheet or mat.
| Size, width × height | Narrowest part | Cut length | Fit on a 12 in sheet | Rule of thumb |
|---|---|---|---|---|
| 1 × 0.74 in (25 × 19 mm) | 1.1 mm | 115 mm | 120 | Vinyl, card and thin sheet |
| 2 × 1.48 in (51 × 38 mm) | 2.1 mm | 231 mm | 35 | Vinyl, card and thin sheet |
| 3 × 2.22 in (76 × 56 mm) | 3.2 mm | 346 mm | 15 | Any material, including 3 mm wood and acrylic |
| 4 × 2.96 in (102 × 75 mm) | 4.3 mm | 461 mm | 6 | Any material, including 3 mm wood and acrylic |
| 6 × 4.43 in (152 × 113 mm) | 6.4 mm | 692 mm | 2 | Any material, including 3 mm wood and acrylic |
| 8 × 5.91 in (203 × 150 mm) | 8.5 mm | 923 mm | 1 | Any material, including 3 mm wood and acrylic |
| 12 × 8.87 in (305 × 225 mm) | 13 mm | 1,384 mm | 1 | Any material, including 3 mm wood and acrylic |
The narrowest part is the thinnest neck or wall beside a cut-out; sharp tips are not counted. For wood and acrylic, keep it at least as wide as the sheet is thick. How to open the file in Cricut, Silhouette and laser software.