Pig with a bow SVG
Which one? SVG for Cricut and lasers, DXF for the free Silhouette Studio, PNG to print.
Free for personal and commercial use, no sign-up. What you can do with it.
The pig face with a big bow on top of its head, between the ears. The bow is welded on, with slits to mark its edge and its knot. Cut the bow again in red to layer over it.
What is in the file
| Size | 100 × 95 mm (3.94 × 3.74 in), scales to any size |
|---|---|
| Pieces | One piece: it holds together when cut |
| Outlines to cut | 14: 1 outer edge and 13 cut-outs |
| Cut length | 993 mm at this size |
| Narrowest part | 2.6 mm at this size |
| Nodes | 219 curve and line segments |
| Symmetry | Mirror |
| Also found as | Pig with red bow SVG |
Measured from the file. PNG: 2,000 × 1,906 pixels, transparent. About the three file types.
Will it cut at your size?
Scaling a design scales its thinnest part too. Here is this one at seven sizes, from 1 to 12 inches on its longer side, with how many copies fit a 12 × 12 inch sheet or mat.
| Size, width × height | Narrowest part | Cut length | Fit on a 12 in sheet | Rule of thumb |
|---|---|---|---|---|
| 1 × 0.95 in (25 × 24 mm) | 0.66 mm | 252 mm | 100 | Fine detail: vinyl and paper only, weed with care |
| 2 × 1.9 in (51 × 48 mm) | 1.3 mm | 504 mm | 25 | Vinyl, card and thin sheet |
| 3 × 2.85 in (76 × 72 mm) | 2 mm | 757 mm | 9 | Vinyl, card and thin sheet |
| 4 × 3.8 in (102 × 97 mm) | 2.6 mm | 1,009 mm | 6 | Vinyl, card and thin sheet |
| 6 × 5.71 in (152 × 145 mm) | 4 mm | 1,513 mm | 2 | Any material, including 3 mm wood and acrylic |
| 8 × 7.61 in (203 × 193 mm) | 5.3 mm | 2,018 mm | 1 | Any material, including 3 mm wood and acrylic |
| 12 × 11.41 in (305 × 290 mm) | 7.9 mm | 3,027 mm | 1 | Any material, including 3 mm wood and acrylic |
The narrowest part is the thinnest neck or wall beside a cut-out; sharp tips are not counted. For wood and acrylic, keep it at least as wide as the sheet is thick. How to open the file in Cricut, Silhouette and laser software.