Free earring SVG

Leaf earring templates SVG

Which one? SVG for Cricut and lasers, DXF for the free Silhouette Studio, PNG to print.

Free for personal and commercial use, no sign-up. What you can do with it.

Leaf earring templates, as a solid black shape
Leaf earring templates. The preview is the SVG file itself.

A pair of leaves that hang by the stem end, point down, with a midrib and five pairs of veins cut through. The veins stop short of the edge, so each leaf is one piece. Made to wear at 50 mm tall.

What is in the file

Size100 × 100 mm (3.94 × 3.94 in), scales to any size
Pieces2 separate pieces
Outlines to cut6: 2 outer edges and 4 cut-outs
Cut length1,454 mm at this size
Narrowest part3.1 mm at this size
Nodes126 curve and line segments
SymmetryMirror

Measured from the file. PNG: 2,000 × 2,000 pixels, transparent. About the three file types.

Will it cut at your size?

Scaling a design scales its thinnest part too. Here is this one at seven sizes, from 1 to 12 inches on its longer side, with how many copies fit a 12 × 12 inch sheet or mat.

Size, width × heightNarrowest partCut lengthFit on a 12 in sheetRule of thumb
1 × 1 in (25 × 25 mm)0.79 mm369 mm100Fine detail: vinyl and paper only, weed with care
2 × 2 in (51 × 51 mm)1.6 mm739 mm25Vinyl, card and thin sheet
3 × 3 in (76 × 76 mm)2.4 mm1,108 mm9Vinyl, card and thin sheet
4 × 4 in (102 × 102 mm)3.1 mm1,477 mm4Any material, including 3 mm wood and acrylic
6 × 6 in (152 × 152 mm)4.7 mm2,216 mm1Any material, including 3 mm wood and acrylic
8 × 8 in (203 × 203 mm)6.3 mm2,955 mm1Any material, including 3 mm wood and acrylic
12 × 12 in (305 × 305 mm)9.4 mm4,432 mm1Any material, including 3 mm wood and acrylic

The narrowest part is the thinnest neck or wall beside a cut-out; sharp tips are not counted. For wood and acrylic, keep it at least as wide as the sheet is thick. How to open the file in Cricut, Silhouette and laser software.

More earring SVG files

← Scalloped earring card for two pairs All 18 earrings Petal earring blanks →