Free earring SVG

Layered kite earrings SVG

Which one? SVG for Cricut and lasers, DXF for the free Silhouette Studio, PNG to print.

Free for personal and commercial use, no sign-up. What you can do with it.

Layered kite earrings, in layered colours
Layered kite earrings. The preview is the SVG file itself.

Three kite shapes in three sizes that hang from the same hole, one on top of the next, as a pair. Cut each layer from a different colour and stack them on one jump ring.

What is in the file

Size100 × 95 mm (3.94 × 3.76 in), scales to any size
Pieces6 separate pieces
Outlines to cut12: 6 outer edges and 6 cut-outs
Cut length1,036 mm at this size
Narrowest part2.8 mm at this size
Nodes104 curve and line segments
SymmetryMirror
Layers3: back, middle and front

Measured from the file. PNG: 2,000 × 1,912 pixels, transparent. About the three file types.

Will it cut at your size?

Scaling a design scales its thinnest part too. Here is this one at seven sizes, from 1 to 12 inches on its longer side, with how many copies fit a 12 × 12 inch sheet or mat.

Size, width × heightNarrowest partCut lengthFit on a 12 in sheetRule of thumb
1 × 0.95 in (25 × 24 mm)0.71 mm263 mm100Fine detail: vinyl and paper only, weed with care
2 × 1.91 in (51 × 48 mm)1.4 mm526 mm25Vinyl, card and thin sheet
3 × 2.86 in (76 × 73 mm)2.1 mm789 mm9Vinyl, card and thin sheet
4 × 3.82 in (102 × 97 mm)2.8 mm1,053 mm6Vinyl, card and thin sheet
6 × 5.72 in (152 × 145 mm)4.3 mm1,579 mm2Any material, including 3 mm wood and acrylic
8 × 7.63 in (203 × 194 mm)5.7 mm2,105 mm1Any material, including 3 mm wood and acrylic
12 × 11.45 in (305 × 291 mm)8.5 mm3,158 mm1Any material, including 3 mm wood and acrylic

The narrowest part is the thinnest neck or wall beside a cut-out; sharp tips are not counted. For wood and acrylic, keep it at least as wide as the sheet is thick. How to open the file in Cricut, Silhouette and laser software.

More earring SVG files

← Geometric crystal earrings All 18 earrings Crescent hoop earrings →