Bull head from the side SVG
Which one? SVG for Cricut and lasers, DXF for the free Silhouette Studio, PNG to print.
Free for personal and commercial use, no sign-up. What you can do with it.
The head and neck of a bull in profile, cut off square behind the shoulder: a short horn, a leaf ear, the eye, the nostril and the line of the mouth. For a sign, a brand board or a gate plaque.
What is in the file
| Size | 100 × 92 mm (3.94 × 3.62 in), scales to any size |
|---|---|
| Pieces | One piece: it holds together when cut |
| Outlines to cut | 4: 1 outer edge and 3 cut-outs |
| Cut length | 449 mm at this size |
| Narrowest part | 1 mm at this size |
| Nodes | 178 curve and line segments |
Measured from the file. PNG: 2,000 × 1,846 pixels, transparent. About the three file types.
Will it cut at your size?
Scaling a design scales its thinnest part too. Here is this one at seven sizes, from 1 to 12 inches on its longer side, with how many copies fit a 12 × 12 inch sheet or mat.
| Size, width × height | Narrowest part | Cut length | Fit on a 12 in sheet | Rule of thumb |
|---|---|---|---|---|
| 1 × 0.92 in (25 × 23 mm) | 0.25 mm | 114 mm | 100 | Too fine for most machines |
| 2 × 1.84 in (51 × 47 mm) | 0.51 mm | 228 mm | 25 | Fine detail: vinyl and paper only, weed with care |
| 3 × 2.76 in (76 × 70 mm) | 0.76 mm | 342 mm | 12 | Fine detail: vinyl and paper only, weed with care |
| 4 × 3.68 in (102 × 93 mm) | 1 mm | 456 mm | 6 | Vinyl, card and thin sheet |
| 6 × 5.52 in (152 × 140 mm) | 1.5 mm | 684 mm | 2 | Vinyl, card and thin sheet |
| 8 × 7.36 in (203 × 187 mm) | 2 mm | 912 mm | 1 | Vinyl, card and thin sheet |
| 12 × 11.04 in (305 × 280 mm) | 3 mm | 1,369 mm | 1 | Any material, including 3 mm wood and acrylic |
The narrowest part is the thinnest neck or wall beside a cut-out; sharp tips are not counted. For wood and acrylic, keep it at least as wide as the sheet is thick. How to open the file in Cricut, Silhouette and laser software.