Layered elk in four colours SVG
Which one? SVG for Cricut and lasers, DXF for the free Silhouette Studio, PNG to print.
Free for personal and commercial use, no sign-up. What you can do with it.
Four layers to stack: blue-grey mountains, a tan bull elk, the dark brown neck, head and legs, and the pale rump patch on top. Cut each from its own colour of card or vinyl.
What is in the file
| Size | 86 × 100 mm (3.4 × 3.94 in), scales to any size |
|---|---|
| Pieces | 7 separate pieces |
| Outlines to cut | 9: 7 outer edges and 2 cut-outs |
| Cut length | 1,195 mm at this size |
| Narrowest part | Nothing narrower than 6 mm at this size |
| Nodes | 470 curve and line segments |
| Layers | 4: mountains, elk, neck, head and legs and rump |
Measured from the file. PNG: 1,738 × 2,000 pixels, transparent. About the three file types.
Will it cut at your size?
Scaling a design scales its thinnest part too. Here is this one at seven sizes, from 1 to 12 inches on its longer side, with how many copies fit a 12 × 12 inch sheet or mat.
| Size, width × height | Narrowest part | Cut length | Fit on a 12 in sheet | Rule of thumb |
|---|---|---|---|---|
| 0.86 × 1 in (22 × 25 mm) | Over 1.5 mm | 304 mm | 110 | Vinyl, card and thin sheet |
| 1.73 × 2 in (44 × 51 mm) | Over 3 mm | 607 mm | 30 | Any material, including 3 mm wood and acrylic |
| 2.59 × 3 in (66 × 76 mm) | Over 4.6 mm | 911 mm | 12 | Any material, including 3 mm wood and acrylic |
| 3.46 × 4 in (88 × 102 mm) | Over 6.1 mm | 1,214 mm | 6 | Any material, including 3 mm wood and acrylic |
| 5.18 × 6 in (132 × 152 mm) | Over 9.1 mm | 1,821 mm | 2 | Any material, including 3 mm wood and acrylic |
| 6.91 × 8 in (176 × 203 mm) | Over 12 mm | 2,428 mm | 1 | Any material, including 3 mm wood and acrylic |
| 10.37 × 12 in (263 × 305 mm) | Over 18 mm | 3,642 mm | 1 | Any material, including 3 mm wood and acrylic |
The narrowest part is the thinnest neck or wall beside a cut-out; sharp tips are not counted. For wood and acrylic, keep it at least as wide as the sheet is thick. How to open the file in Cricut, Silhouette and laser software.