Leafy vine with tendrils SVG
Which one? SVG for Cricut and lasers, DXF for the free Silhouette Studio, PNG to print.
Free for personal and commercial use, no sign-up. What you can do with it.
A stem that waves gently from left to right with ten leaves set alternately along it, each with a slit for its midrib, and a curl of tendril at both ends. The plain vine for edges and underlines.
What is in the file
| Size | 100 × 39 mm (3.94 × 1.52 in), scales to any size |
|---|---|
| Pieces | One piece: it holds together when cut |
| Outlines to cut | 12: 1 outer edge and 11 cut-outs |
| Cut length | 735 mm at this size |
| Narrowest part | 2 mm at this size |
| Nodes | 221 curve and line segments |
| Also found as | Leaves vine SVG |
Measured from the file. PNG: 2,000 × 819 pixels, transparent. About the three file types.
Will it cut at your size?
Scaling a design scales its thinnest part too. Here is this one at seven sizes, from 1 to 12 inches on its longer side, with how many copies fit a 12 × 12 inch sheet or mat.
| Size, width × height | Narrowest part | Cut length | Fit on a 12 in sheet | Rule of thumb |
|---|---|---|---|---|
| 1 × 0.39 in (25 × 10 mm) | 0.51 mm | 187 mm | 200 | Fine detail: vinyl and paper only, weed with care |
| 2 × 0.77 in (51 × 20 mm) | 1 mm | 373 mm | 60 | Vinyl, card and thin sheet |
| 3 × 1.16 in (76 × 29 mm) | 1.5 mm | 560 mm | 24 | Vinyl, card and thin sheet |
| 4 × 1.54 in (102 × 39 mm) | 2 mm | 747 mm | 12 | Vinyl, card and thin sheet |
| 6 × 2.32 in (152 × 59 mm) | 3 mm | 1,120 mm | 4 | Any material, including 3 mm wood and acrylic |
| 8 × 3.09 in (203 × 78 mm) | 4.1 mm | 1,494 mm | 3 | Any material, including 3 mm wood and acrylic |
| 12 × 4.63 in (305 × 118 mm) | 6.1 mm | 2,240 mm | 2 | Any material, including 3 mm wood and acrylic |
The narrowest part is the thinnest neck or wall beside a cut-out; sharp tips are not counted. For wood and acrylic, keep it at least as wide as the sheet is thick. How to open the file in Cricut, Silhouette and laser software.