Free surfboard SVG

Surfboard with two stripes SVG

Surfboard with two stripes, as a solid black shape
Surfboard with two stripes. The preview is the SVG file itself.

A pointed shortboard seen from above, nose up: two slanting stripes across the middle and a stringer line above and below them. The stripes stop inside the rails, so the board is one piece.

Free for personal and commercial use, no sign-up. What you can do with it.

What is in the file

Size24 × 100 mm (0.94 × 3.94 in), scales to any size
PiecesOne piece: it holds together when cut
Outlines to cut5: 1 outer edge and 4 cut-outs
Cut length415 mm at this size
Narrowest part2.6 mm at this size
Nodes59 curve and line segments

Measured from the file. PNG: 538 × 2,000 pixels, transparent. About the three file types.

Will it cut at your size?

Scaling a design scales its thinnest part too. Here is this one at seven sizes, from 1 to 12 inches on its longer side, with how many copies fit a 12 × 12 inch sheet or mat.

Size, width × heightNarrowest partCut lengthFit on a 12 in sheetRule of thumb
0.24 × 1 in (6 × 25 mm)0.66 mm105 mm270Fine detail: vinyl and paper only, weed with care
0.48 × 2 in (12 × 51 mm)1.3 mm211 mm85Vinyl, card and thin sheet
0.72 × 3 in (18 × 76 mm)2 mm316 mm39Vinyl, card and thin sheet
0.96 × 4 in (24 × 102 mm)2.6 mm422 mm20Vinyl, card and thin sheet
1.44 × 6 in (37 × 152 mm)4 mm632 mm7Any material, including 3 mm wood and acrylic
1.92 × 8 in (49 × 203 mm)5.3 mm843 mm5Any material, including 3 mm wood and acrylic
2.88 × 12 in (73 × 305 mm)7.9 mm1,265 mm3Any material, including 3 mm wood and acrylic

The narrowest part is the thinnest neck that holds the design together; sharp tips are not counted. For wood and acrylic, keep it at least as wide as the sheet is thick. How to open the file in Cricut, Silhouette and laser software.

More surfboard SVG files

← Layered surfboard in six colours All 15 surfboards Surfboard silhouette standing in sand →