Free key SVG

Keyhole plate for a key SVG

Keyhole plate for a key, as a solid black shape
Keyhole plate for a key. The preview is the SVG file itself.

The brass plate that goes round a keyhole on an old door: a tall shield with a knob at each end, two screw holes and the keyhole in the middle. A good partner for any key here.

Free for personal and commercial use, no sign-up. What you can do with it.

What is in the file

Size58 × 100 mm (2.27 × 3.94 in), scales to any size
PiecesOne piece: it holds together when cut
Outlines to cut4: 1 outer edge and 3 cut-outs
Cut length390 mm at this size
Narrowest partNothing narrower than 6 mm at this size
Nodes39 curve and line segments
SymmetryMirror

Measured from the file. PNG: 1,187 × 2,000 pixels, transparent. About the three file types.

Will it cut at your size?

Scaling a design scales its thinnest part too. Here is this one at seven sizes, from 1 to 12 inches on its longer side, with how many copies fit a 12 × 12 inch sheet or mat.

Size, width × heightNarrowest partCut lengthFit on a 12 in sheetRule of thumb
0.58 × 1 in (15 × 25 mm)Over 1.5 mm99 mm150Vinyl, card and thin sheet
1.15 × 2 in (29 × 51 mm)Over 3 mm198 mm45Any material, including 3 mm wood and acrylic
1.73 × 3 in (44 × 76 mm)Over 4.6 mm297 mm18Any material, including 3 mm wood and acrylic
2.31 × 4 in (59 × 102 mm)Over 6.1 mm396 mm8Any material, including 3 mm wood and acrylic
3.46 × 6 in (88 × 152 mm)Over 9.1 mm594 mm3Any material, including 3 mm wood and acrylic
4.62 × 8 in (117 × 203 mm)Over 12 mm792 mm2Any material, including 3 mm wood and acrylic
6.92 × 12 in (176 × 305 mm)Over 18 mm1,189 mm1Any material, including 3 mm wood and acrylic

The narrowest part is the thinnest neck that holds the design together; sharp tips are not counted. For wood and acrylic, keep it at least as wide as the sheet is thick. How to open the file in Cricut, Silhouette and laser software.

More key SVG files

← Lock and key All 15 keys Two crossed keys →