Leaping marlin fish SVG
Which one? SVG for Cricut and lasers, DXF for the free Silhouette Studio, PNG to print.
Free for personal and commercial use, no sign-up. What you can do with it.
A marlin arched in a jump: the long bill, a tall pointed dorsal fin, a crescent tail and bars down its back. A sport-fishing silhouette for boat names and tumblers.
What is in the file
| Size | 100 × 73 mm (3.94 × 2.89 in), scales to any size |
|---|---|
| Pieces | One piece: it holds together when cut |
| Outlines to cut | 9: 1 outer edge and 8 cut-outs |
| Cut length | 505 mm at this size |
| Narrowest part | 1.2 mm at this size |
| Nodes | 183 curve and line segments |
Measured from the file. PNG: 2,000 × 1,487 pixels, transparent. About the three file types.
Will it cut at your size?
Scaling a design scales its thinnest part too. Here is this one at seven sizes, from 1 to 12 inches on its longer side, with how many copies fit a 12 × 12 inch sheet or mat.
| Size, width × height | Narrowest part | Cut length | Fit on a 12 in sheet | Rule of thumb |
|---|---|---|---|---|
| 1 × 0.73 in (25 × 19 mm) | 0.3 mm | 128 mm | 130 | Too fine for most machines |
| 2 × 1.47 in (51 × 37 mm) | 0.61 mm | 257 mm | 35 | Fine detail: vinyl and paper only, weed with care |
| 3 × 2.2 in (76 × 56 mm) | 0.91 mm | 385 mm | 15 | Fine detail: vinyl and paper only, weed with care |
| 4 × 2.93 in (102 × 74 mm) | 1.2 mm | 513 mm | 6 | Vinyl, card and thin sheet |
| 6 × 4.4 in (152 × 112 mm) | 1.8 mm | 770 mm | 2 | Vinyl, card and thin sheet |
| 8 × 5.86 in (203 × 149 mm) | 2.4 mm | 1,026 mm | 2 | Vinyl, card and thin sheet |
| 12 × 8.8 in (305 × 223 mm) | 3.7 mm | 1,539 mm | 1 | Any material, including 3 mm wood and acrylic |
The narrowest part is the thinnest neck or wall beside a cut-out; sharp tips are not counted. For wood and acrylic, keep it at least as wide as the sheet is thick. How to open the file in Cricut, Silhouette and laser software.