Free emoji SVG

Party emoji with a hat and blower SVG

Which one? SVG for Cricut and lasers, DXF for the free Silhouette Studio, PNG to print.

Free for personal and commercial use, no sign-up. What you can do with it.

Party emoji with a hat and blower. The preview is the SVG file itself.

A smiling face in a striped party hat with a pom-pom, blowing a party horn that curls at its end. Hat and horn reach past the edge and are welded on. For birthday banners and invitations.

What is in the file

Size	82 × 100 mm (3.21 × 3.94 in), scales to any size
Pieces	One piece: it holds together when cut
Outlines to cut	11: 1 outer edge and 10 cut-outs
Cut length	727 mm at this size
Narrowest part	1.8 mm at this size
Nodes	119 curve and line segments

Measured from the file. PNG: 1,644 × 2,000 pixels, transparent. About the three file types.

Will it cut at your size?

Scaling a design scales its thinnest part too. Here is this one at seven sizes, from 1 to 12 inches on its longer side, with how many copies fit a 12 × 12 inch sheet or mat.

Size, width × height	Narrowest part	Cut length	Fit on a 12 in sheet	Rule of thumb
0.82 × 1 in (21 × 25 mm)	0.46 mm	185 mm	120	Too fine for most machines
1.63 × 2 in (41 × 51 mm)	0.91 mm	369 mm	30	Fine detail: vinyl and paper only, weed with care
2.44 × 3 in (62 × 76 mm)	1.4 mm	554 mm	12	Vinyl, card and thin sheet
3.26 × 4 in (83 × 102 mm)	1.8 mm	739 mm	6	Vinyl, card and thin sheet
4.89 × 6 in (124 × 152 mm)	2.7 mm	1,108 mm	2	Vinyl, card and thin sheet
6.52 × 8 in (166 × 203 mm)	3.7 mm	1,477 mm	1	Any material, including 3 mm wood and acrylic
9.78 × 12 in (248 × 305 mm)	5.5 mm	2,216 mm	1	Any material, including 3 mm wood and acrylic

The narrowest part is the thinnest neck that holds the design together; sharp tips are not counted. For wood and acrylic, keep it at least as wide as the sheet is thick. How to open the file in Cricut, Silhouette and laser software.

More emoji SVG files

← Emoji wearing a face mask All 18 emojis Crazy emoji with its tongue out →