Oval name plate SVG
Which one? SVG for Cricut and lasers, DXF for the free Silhouette Studio, PNG to print.
Free for personal and commercial use, no sign-up. What you can do with it.
A long oval with a screw hole at each end and a fine line cut just inside the edge. Made for door plates, drawer labels and trophy plaques: engrave or stick the name in the middle.
What is in the file
| Size | 100 × 58 mm (3.94 × 2.28 in), scales to any size |
|---|---|
| Pieces | One piece: it holds together when cut |
| Outlines to cut | 7: 1 outer edge and 6 cut-outs |
| Cut length | 611 mm at this size |
| Narrowest part | 4.8 mm at this size |
| Nodes | 46 curve and line segments |
| Symmetry | 2-fold rotation and mirror |
Measured from the file. PNG: 2,000 × 1,192 pixels, transparent. About the three file types.
Will it cut at your size?
Scaling a design scales its thinnest part too. Here is this one at seven sizes, from 1 to 12 inches on its longer side, with how many copies fit a 12 × 12 inch sheet or mat.
| Size, width × height | Narrowest part | Cut length | Fit on a 12 in sheet | Rule of thumb |
|---|---|---|---|---|
| 1 × 0.58 in (25 × 15 mm) | 1.2 mm | 155 mm | 150 | Vinyl, card and thin sheet |
| 2 × 1.16 in (51 × 29 mm) | 2.4 mm | 310 mm | 40 | Vinyl, card and thin sheet |
| 3 × 1.74 in (76 × 44 mm) | 3.7 mm | 466 mm | 18 | Any material, including 3 mm wood and acrylic |
| 4 × 2.32 in (102 × 59 mm) | 4.9 mm | 621 mm | 8 | Any material, including 3 mm wood and acrylic |
| 6 × 3.48 in (152 × 88 mm) | 7.3 mm | 931 mm | 3 | Any material, including 3 mm wood and acrylic |
| 8 × 4.64 in (203 × 118 mm) | 9.8 mm | 1,242 mm | 2 | Any material, including 3 mm wood and acrylic |
| 12 × 6.96 in (305 × 177 mm) | 15 mm | 1,862 mm | 1 | Any material, including 3 mm wood and acrylic |
The narrowest part is the thinnest neck or wall beside a cut-out; sharp tips are not counted. For wood and acrylic, keep it at least as wide as the sheet is thick. How to open the file in Cricut, Silhouette and laser software.