Heart wreath of leaves SVG
Which one? SVG for Cricut and lasers, DXF for the free Silhouette Studio, PNG to print.
Free for personal and commercial use, no sign-up. What you can do with it.
Two leafy sprigs that climb from the point and meet at the notch, tracing a heart. Leaves alternate inside and outside the stem, and the open middle takes a name or a monogram.
What is in the file
| Size | 100 × 82 mm (3.94 × 3.24 in), scales to any size |
|---|---|
| Pieces | One piece: it holds together when cut |
| Outlines to cut | 3: 1 outer edge and 2 cut-outs |
| Cut length | 936 mm at this size |
| Narrowest part | 2.1 mm at this size |
| Nodes | 232 curve and line segments |
| Symmetry | Mirror |
Measured from the file. PNG: 2,000 × 1,660 pixels, transparent. About the three file types.
Will it cut at your size?
Scaling a design scales its thinnest part too. Here is this one at seven sizes, from 1 to 12 inches on its longer side, with how many copies fit a 12 × 12 inch sheet or mat.
| Size, width × height | Narrowest part | Cut length | Fit on a 12 in sheet | Rule of thumb |
|---|---|---|---|---|
| 1 × 0.82 in (25 × 21 mm) | 0.53 mm | 238 mm | 110 | Fine detail: vinyl and paper only, weed with care |
| 2 × 1.65 in (51 × 42 mm) | 1.1 mm | 475 mm | 30 | Vinyl, card and thin sheet |
| 3 × 2.47 in (76 × 63 mm) | 1.6 mm | 713 mm | 12 | Vinyl, card and thin sheet |
| 4 × 3.29 in (102 × 84 mm) | 2.1 mm | 951 mm | 6 | Vinyl, card and thin sheet |
| 6 × 4.94 in (152 × 125 mm) | 3.2 mm | 1,426 mm | 2 | Any material, including 3 mm wood and acrylic |
| 8 × 6.58 in (203 × 167 mm) | 4.3 mm | 1,902 mm | 1 | Any material, including 3 mm wood and acrylic |
| 12 × 9.88 in (305 × 251 mm) | 6.4 mm | 2,853 mm | 1 | Any material, including 3 mm wood and acrylic |
The narrowest part is the thinnest neck or wall beside a cut-out; sharp tips are not counted. For wood and acrylic, keep it at least as wide as the sheet is thick. How to open the file in Cricut, Silhouette and laser software.